Size- 35mm

*please note* this design was not created by myself, although I do have the rights to sell.

• SPECIFICATIONS •
-All cutters have 0.4 cutting edge designed for a sharp cut. Cutters may have minimal irregularities but these do not affect use. Edges can be smoothed with fingertips or a q-tip and a few drops of rubbing alcohol before baking. Alternatively, using sandpaper or a buffing tool after baking will remove any impurities.
-Measurements are taken of the widest or tallest part of the internal cutting walls. This is the size in which the actual clay piece will measure, and is not representative of the total cutter size.
- Our cutters are 3D printed using PLA (Polylactic acid) which is made of renewable resources such as corn or sugar cane. PLA is a bioplastic that is both biosourced and biodegradable.

•HOW TO USE OUR CUTTERS•
-Once your clay is rolled to your desired thickness (we recommend a minimum of 3mm to ensure cutter imprint shows clear), gently press the cutter into the clay. Slightly wiggle the cutter and lift to remove.
-To help avoid your clay sticking, we recommend dipping your cutter in water or corn starch before use. Cutting directly on your baking tile will also help reduce the chance of sticking.

• CUTTER CARE •
-Wash your cutters in warm water with a mild detergent. A soft tooth brush can help clean tricky spots. Alternatively, you can use a wipe and rubbing alcohol.
-Our cutters are made from PLA and will melt and distort at high heat. They are not oven or dishwasher safe.
-Storing your cutters in a dry container away from direct sunlight will help ensure longevity.

• REFUNDS OR EXCHANGES •
We don’t offer refunds or exchanges for this product due to hygiene reasons but please feel free to let us know if there are damages or breakage upon receipt of this item.
If you have any questions about sizing or how to use your cutter please contact us.